Manufacturing Process and Process Validation in Module 3.2.P.3: What Assessors Expect

Module 3.2.P.3 describes how the finished product is made and how the applicant knows the process works. EMA’s guideline on process validation for finished products sets out what data belong in the dossier, and the distinction it draws between standard and non-standard processes shapes the whole submission strategy.

The structure of 3.2.P.3

  • 3.2.P.3.1 Manufacturers: every site and its responsibility, consistent with Module 1 and the application form.
  • 3.2.P.3.2 Batch formula: the quantities of all components for a defined batch size or range.
  • 3.2.P.3.3 Description of the manufacturing process and process controls: a flow chart and narrative detailed enough for an assessor to understand each step.
  • 3.2.P.3.4 Controls of critical steps and intermediates: tests, acceptance criteria and justification.
  • 3.2.P.3.5 Process validation and/or evaluation: the evidence that the process consistently delivers product of the intended quality.

Standard and non-standard processes

EMA’s guideline on process validation for finished products (Revision 1) distinguishes standard manufacturing processes from non-standard ones. For non-standard processes – for example certain specialised dosage forms, processes with critical steps such as aseptic processing or lyophilisation, or very low-strength products – production-scale validation data are generally expected in the dossier. For standard processes, a process validation scheme can often be submitted instead, with validation at commercial scale completed before the product is placed on the market.

The guideline also accepts traditional validation, continuous process verification, or a hybrid approach, provided the chosen strategy is justified and described.

Writing the process description

Assessors need to see the process as it will actually run. Good practice includes:

  • stating operating ranges for critical parameters rather than single target values where flexibility is needed;
  • describing any reprocessing and its justification;
  • ensuring batch sizes match those tested in stability and validation;
  • keeping the description consistent with GMP documentation at the manufacturing site.

Over-detailed descriptions can also cause problems, since every registered detail may become a variation when it changes. ICH Q12 concepts such as established conditions help applicants define what is binding.

How PQRA helps

PQRA helps applicants classify their processes, decide between full validation data and a validation scheme, and draft 3.2.P.3 sections that are complete without locking in unnecessary detail.

Contact PQRA to discuss your next dossier.

CATEGORIES:

Uncategorized

Tags:

No responses yet

Leave a Reply

Your email address will not be published. Required fields are marked *